| Burn-in Procedure |
| 1. |
After mounting the heat seal band in your machinery, turn on the system and perform an AUTOCAL. |
| 2. |
At the competition of AUTOCAL the Actual Temperature should represent the ambient temperature. |
| 3. |
To Burn-In the band, set the Sealing Temperature to 40°-50°C HIGHER than your target sealing temperature. |
| 4. |
Without closing the jaw bars, initiate the heat for 20 seconds. |
| 5. |
After cooling, the controller will display an Actual Temperature value less than ambient. |
| 6. |
Repeat the AUTOCAL function and Burn-In procedure. |
| 7. |
The band is properly Burned-In when the controller displays an actual temperature equal to ambient temperature after the band cools down. |
| 8. |
Burn-In is now complete. |
| Note: |
Do not exceed a Burn-In temperature of
275°C without the proper Jaw Bar build up
required for high temperatures. |
